Drapery Installation Guide

Beautiful drapery is about more than selecting the perfect fabric—proper installation is what brings each panel to life. From adjusting your hooks to steaming and training your pleats, a few simple finishing steps will help you achieve the tailored, custom look shown throughout our photography. Follow the guide below for our recommended installation process.

Note: We strongly recommend hiring a local handyman to help measure, level, and drill!

Instructions

  • Install Your Drapery Rod

    If you do not have an existing drapery rod up, we recommend hanging your new rod as close to the crown molding as possible (or ceiling if you do not have crown molding). Allow room for your brackets.

    Hanging your curtains higher and wider makes your windows look larger and your ceilings feel taller!

  •  Measure Ring Hook

    Measure the length of the eye hook on your drapery ring. If the eye hook measures 1/2", the top of the drapery pin should sit 1/2" below the top of the panel.

  • Mark Your Placement

    Using that measurement, make a small mark on the back of the panel next to each pleat (with a pencil or erasable fabric marker) measuring down from the top of the drapery panel. 

  • Place Your Pins

    Insert the pins into the seam of the pleat and one at each end inset about 1/2" from edge of panel. The top of each pin should line up with your measurement mark so that they are all positioned at the same height. 

  • Ready To Hang

    Hook each pin through a drapery ring. The top of your drapery panel should sit below the rod. If it sits too high or comes up over the rod, simply reposition the pins until the height is right. You should not be able to see the pins from the front side of the panel.

  • Steam the Pleats

    Shipping folds and creases are normal. Allow panels to relax, hanging for 24–48 hours before steaming vertically from top to bottom. Avoid pressing with a hot iron. Natural linen may relax slightly after hanging.

  • Train the Pleats

    Fold the pleats neatly by hand. Tie them loosely with ribbon, fabric strips, or soft ties. Leave tied for 24–72 hours if desired. Allow the folds to set naturally.

    Note: this step is not required.

Pro Tips

For the most tailored appearance, we recommend:

Installing your rod as high and wide as possible

Steaming your panels after hanging

Allowing natural linen to settle for 48–72 hours before making final adjustments

Taking time to train the pleats for beautifully consistent folds